Loewe Connect 32 User Manual page 87

Connect 32
User manual
System settings
Control
Software update via USB storage device
To do this, plug the USB stick with the downloaded software into a
free USB port of the TV set.
Calling Software update
HOME: Call Home view.
Mark System settings,
OK call System settings.
Mark Control,
go to next column.
Mark Software,
go to next column.
Mark Software update,
go to next column.
Mark Via USB,
call Software update.
The version of the software package that is
currently installed will be displayed.
SOFTWARE UPDATE WIZARD - Current software
Current software: 1.1.11.0
... ... Via USB
To load a new piece of software, you first need to search for said software on a
USB storage device that is connected (e.g. USB stick). Press the
the search.
Proceed with
Proceed.
The TV set searches for a new software package
on the USB stick.
If a new software version is available after the search,
an on-screen message appears (see right hand
column).
If several different software packages are found on the
USB stick, the latest software package is always used.
If no new software package was found in the search:
BACK: End of wizard.
key to start
Cancel with
New software package found
New software
A new software version was found. A new software version was found.
... ... Via USB
New software: V1.1.14.0 (Current software: V.1.1.11.0) New software: V1.1.14.0 (Current software: V.1.1.11.0)
If you now wish to load the new software, press the If you now wish to load the new software, press the
close with the close with the
Ensure that the TV set is not switched off at the mains while it is loading the Ensure that the TV set is not switched off at the mains while it is loading the
data. data.
Proceed with Proceed with
Proceed starts loading of the new software.
Or:
BACK: End of wizard.
The update will then not be carried out.
Load new software package
Updating software
The "V1.1.14.0" software is currently being programmed, please wait ...
... ... Via USB
Note: The loading and programming process can take up to approx. 50 minutes Note: The loading and programming process can take up to approx. 50 minutes
in total. Please do not switch off your TV set at the mains during the loading and in total. Please do not switch off your TV set at the mains during the loading and
programming process. programming process.
Note: Depending on the loaded software, it is possible that the device cannot Note: Depending on the loaded software, it is possible that the device cannot
automatically switch off after the update. Therefore, please monitor the automatically switch off after the update. Therefore, please monitor the
update process. update process.
The software is loaded in several steps. The total loading
and programming process can take up to approx. 50
minutes in total.
Please do not switch off your TV set with the mains
switch during the entire loading and programming
process.
After the update, the TV set is automatically powered
off and on again.
Depending on the software loaded, it is possible that
the device may not turn off automatically after the
update. Therefore, please supervise the update
process.
When the TV set is switched on again, a message is
displayed.
BACK: End of wizard.
button. Otherwise button. Otherwise
button. button.
End with End with
60%
Hint
The software was successfully updated.
Finish wizard with
87