Loewe Connect 32 User Manual page 20

Connect 32
User manual
Initial installation
Setting options for DVB-T reception:
If you have not selected Terrestrial (DVB-T) in step Connect
antenna cable(s) in the initial installation, proceed to the next section
Setting options for DVB-C reception.
Network
selection
Network selection (DVB-T)
Please state from which network you wish to receive your station.
Note: The newly selected parameter must be confirmed with the
Freeview
other network
Back with
If several networks are available via DVB-T, you can
decide which network you want to receive your
channels from.
Select network,
OK Confirm selection.
Proceed to next step.
Settings
DVB-T settings
Please specify whether you want to search for scrambled stations too.
Note: Scrambled stations can only be received with an integrated CA module and
additional card.
Scrambled stations
Search method
Accept Logical Channel Number
Back with
Select and adapt settings for DVB-T reception.
Scrambled You can state whether coded stations are to be
stations searched for in the search/update.
Select yes to save all found scrambled stations.
However, these stations can only be received in
connection with a CA module and the appropriate
Smart Card.
The handling of the CA module is described in the
chapter System settings, section Extras – CA
module.
Search If you want to run the station search independently
method of the channel grid, select Frequency search for
the search method.
Accept In various countries, digital stations (DVB-T) are
Logical transmitted with a preset channel number per
Channel station, known as Logical Channel Numbers (LCN).
Number
If you select yes here, these default channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. The stations in the
station list can no longer be shifted.
Proceed to next step.
20
button.
OK
Proceed with
no yes
Channel search Frequency search
no yes
Proceed with
Supply
voltage
Supply voltage DVB-T antenna
Please state here whether your DVB-T antenna needs a supply voltage. Antennas with an
integrated amplifier need a supply voltage on the antenna line.
no (0V) yes (5V)
Back with Proceed with
Select supply voltage no / yes.
If you use a DVB-T antenna that requires a supply
voltage (active antenna) and which is not already
supplied via a power adaptor, then select yes (5V)
for the antenna's power supply.
How to align your DVB-T antenna is described in
chapter System settings, section Connections
– Antenna DVB.
Proceed to next step.