Loewe Connect 32 User Manual page 110

Connect 32
User manual
System settings
Extras
Searching for scrambled stations
If no search for encrypted stations was performed during initial startup,
this can be done later using the search wizard.
HOME: Call Home view.
Select System settings,
OK call System settings.
Mark Stations,
go to next column.
Automatic scan TV+Radio,
go to next column.
Select Change search settings,
OK wizard guides you through the search settings.
Under scrambled stations you have to select yes.
Next select Start search/update,
OK start updating the station list.
Calling CA module information
This menu is only available when a CA module is
plugged in.
HOME: Call Home view.
Mark System settings,
OK call System settings.
Mark Extras,
go to next column.
Select desired CA module.
The indicated name depends on the inserted
CA module.
go to next column.
Select Module menu,
OK call information.
The content of this menu depends on the provider of
the CA module.
Smartcard rights
If two CA modules are used in parallel to decode stations, you specify
here the rights of both smartcards.
Mark Smartcard rights
go to next column.
Select Same rights or Different rights.
If you select Same rights, the TV set assumes that
both smartcards have the same rights and can be used
for Dual Recording in parallel. In this case, the Station
mapping function is not available.
When selecting Different rights, you can assign the
stations to be decoded to the respective CA module.
110
Station mapping
If two CA modules are both used for the decoding of stations, you
decide here which station shall be decoded by which CA module.
The station mapping settings will only be taken into account, if two
CA modules are plugged.
This menu item is only available if under Smartcard rights the
item Different rights was selected.
This statement refers explicitly to the CI slots of the TV set and not
to the modules plugged into it! When the modules are exchanged,
the mapping must be repeated.
Mark Station Mapping,
call station list.
Select CA module for mapping.
Mark station,
OK map station to the selected CA module / cancel
mapping.
Behind the assigned station is the number of the
corresponding CI slot.
Storage the PIN for recordings
Store the programme provider PIN belonging to your CA module in
order to decode CI plus programmes with parental lock for recording.
The menu option is available only if the plugged CA module supports
storing the parental lock PIN.
Mark Storage of PIN for recordings,
call PIN entry box.
Mark the desired CA module in the headline.
Go to the PIN input line, use the numerical keys
to enter the programme provider PIN.
Or:
Mark figure,
OK adopt figure to input line.
To conclude the entry:
Mark Adopt,
OK save PIN.
Removing the CA module
Switch off TV set using the mains switch.
Remove the cover from the rear of the set.
Pull the CA module out of the CI slot.
Replace the cover.