Loewe Connect 32 User Manual page 51

Connect 32
User manual
TV
Timer
New recording – Manual recording (current station)
In the Timer list, New recording is selected.
Mark recording duration.
The selection of a recording duration programmes
always a recording of the currently viewed station.
For Any station and time see below.
OK Call Timer data dialogue.
The selected recording duration is preset in the
timer data. Check timer data and correct them,
if required. In case of a previous selection of
??? Min, enter definitely the recording dura-
tion.
Mark Adopt to Timer.
OK Confirm timer data and adopt timer instruction.
Recording has been started.
New recording – Manual recording (other station)
Manual recording has been selected (see above).
Mark Any station and time,
OK Call Station selection.
Mark desired station,
OK Adopt station in timer data.
Check timer data and correct them, if required.
Mark Adopt to Timer.
OK Confirm timer data and adopt timer instruction.
New recording – Current programme
After calling the Current programme the timer data dialogue will be
displayed. The current programme is preset in the timer data.
Check timer data and correct them, if required.
Mark Adopt to Timer.
OK Confirm timer data and adopt timer instruction.
Recording has been started.
New recording – Following programme
After calling the Following programme the timer data dialogue will
be displayed. The following programme of the current station is preset
in the timer data.
Check timer data and correct them, if required.
Mark Adopt to Timer.
OK Confirm timer data and adopt timer instruction.
New copy job
You should copy recordings that you want to save permanently on an
external USB hard disk.
Copying recordings, which originate from a CI Plus encrypted station,
is perhaps not possible or only to a limited extent.
In the Timer list:
Mark Create newly,
OK call.
Mark New copy,
OK call.
The DR+ archive will be called.
For further information for exporting archive entries
refer to chapter TV, section Digital-Recorder –
Export of archive entries.
Record conflict
When programming a new recording, it can happen that there will be
an overlapping with already stored timer recordings. In this case, the
recording conflict dialogue will open.
Here you can determine which of the recordings you want to be
executed, and you must eventually specify which of the programmes
shall be fully recorded and which are cut.
Select recording,
OK change status.
The symbol before the recording shows you what
happens to the recording.
If the status for each recording is ok:
Mark store recordings,
OK call.
The timer data of the recordings will be adjusted
accordingly.
Explanation of the symbols in the conflict manager:
TV programme is completely recorded.
Recording is cut off (at the beginning and/or end). Pay
attention to the start and end time of the recording.
The recording is deleted.
51