Loewe Connect 32 User Manual page 21

Connect 32
User manual
Initial installation
Setting options for DVB-C reception:
If you have not selected Cable (DVB-C) in step Connect antenna
cable(s) in the initial installation, proceed to the next section Setting
options for DVB-S reception.
Network
selection
Network selection (DVB-C)
Please state from which network you wish to receive your station.
Note: The newly selected parameter must be confirmed with the
Unitymedia
Standard
Back with
If several networks are available via DVB-C, you can
decide which network you want to receive your
channels from.
The normal DVB-C settings are derived from the
selection of the location or network and do not need
to be changed.
Exactly which of the following settings are present is
dependent on which network is selected.
Select network.
OK Confirm selection.
Proceed to next step.
Settings
DVB-C settings
Please specify whether you want to search for scrambled stations too.
Note: Scrambled stations can only be received with an integrated CA module and additional
card.
Scrambled stations
Search method
Start frequency
Network ID
Accept Logical Channel Number
Back with
Select and adapt settings for DVB-C
reception.
Scrambled You can state whether coded stations are to be
stations searched for in the search/update.
Select yes to save all found scrambled stations.
However, these stations can only be received in
connection with a CA module and the appropriate
Smart Card.
The handling of the CA module is described in the
chapter System settings, section Extras – CA
module.
Search If you select Frequency search here, a search is
method performed for all receivable stations.
With Network search, only the stations which
the networks supply are searched - either for
all receivable networks or only for the particular
network specified under Network ID.
Start The DVB stations are only searched for in the
frequency frequency range above the start frequency.
button.
OK
Proceed with
no yes
Network search Frequency search
044.00 MHz
none 00000
no yes
Proceed with
Network ID If you select none here, DVB signals of all current
transmitter networks are searched automatically
(recommended for most cable networks).
If, on the other hand, you specify a certain network ID
(necessary in the cable networks of some countries),
only DVB signals of this broadcasting network are
searched for automatically.
Your cable provider has the information you need.
Accept In various countries, digital stations (DVB-C) are
Logical transmitted with a preset channel number per
Channel station, known as Logical Channel Numbers (LCN).
Number
If you select yes here, these default channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. The stations in the
station list can no longer be shifted.
Proceed to next step.
21