Loewe Connect 32 User Manual page 26

Connect 32
User manual
Initial installation
Setting options for the satellite system (other communal
installation):
Select
single satellite
Select satellites
Please specify here which satellite you receive.
Note: The newly selected parameter must be confirmed with the
Optus D1160°E
Türksat 42°E
Hellas Sat2 39°E
Eutelsat 36A 36°E
Eutelsat 28A 28,5°E
ASTRA2 28,2°E
ASTRA3 23,5°E
Back with
Select satellite.
OK Confirm selection.
Proceed to next step.
LNB
frequencies,
Supply
LNB frequency, supply voltage
voltage
Please specify the oscillator frequency for your LNB.
If your TV set is connected to a single cable system without an external power supply, you
can connect the antenna supply (13 or 18V/max. 350mA) with „13V" or „18V".
ASTRA1 19,2°E
Supply voltage
Back with
Select and adapt settings.
LNC Normally, you do not need to change the values for
frequency high and low band, unless the LNC (LNB) of your
satellite system uses a different oscillator frequency
(important for the frequency display).
Supply If your set is connected to a single-cable system
voltage without external voltage supply, you can connect
the antenna supply (13V or 18V / max. 500mA).
Proceed to next step.
Proceed to section Setting options for all types of
reception.
26
button.
OK
ASTRA1 19,2°E Eutelsat 5 West A 5°W
Nilesat 7°W
Eutelsat 16A 16°E
Hot Bird 13°E Eutelsat 7 West A 7,2°W
Eurobird 9A 9°E Eutelsat 8 West A 8°W
Eutelsat 12 West A 12,5°W
Eurobird 7A 7°E
ASTRA4A 4,8°E Telestart12 12,5°W
Thor/Intelsat10-02 0,8 Intelsat901 18°W
Proceed with
9750 MHz 10000 MHz 10200 MHz 10600 MHz
off 13V 18V
Proceed with