Table of Contents
Advertisement
14. Align the screw holes on the eDP cable bracket with the screw holes on the system board.
15. Replace the two (M2x3) screws to secure the eDP cable bracket to the system board.
Next steps
1. Install the
assembly inner
2. Install the
system
fan.
3. Install the
3-cell battery
4. Install the
heat sink (integrated)
5. Install the
WWAN
card.
6. Install the
WLAN
card.
7. Install the
memory
module.
8. Install the
M.2 2280 solid-state drive
9. Install the
base
cover.
10. Install the
microSD
card.
11. Install the
SIM
card.
12. Follow the procedure in
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in
2. Remove the
SIM
card.
3. Remove the
microSD
4. Remove the
base
cover.
5. Remove the
M.2 2280 solid-state drive
6. Remove the
memory
module.
7. Remove the
WLAN
card.
8. Remove the
WWAN
card.
9. Remove the
3-cell battery
10. Remove the
system
fan.
11. Remove the
assembly inner
12. Remove the
system
board.
NOTE:
The system board can be removed with the heat sink attached in order to simplify the procedure and preserve
the thermal bond between the system board and heat sink.
About this task
The following images indicate the location of the power-button board and provide a visual representation of the removal
procedure.
frame.
or
4-cell
battery.
or
heat sink
(discrete).
or
M.2 2230 solid-state
after working inside your
before working inside your
card.
or
M.2 2230 solid-state
or
4-cell
battery.
frame.
drive.
computer.
computer.
drive.
Removing and installing components
67
Advertisement
Table of Contents
