Table of Contents
Advertisement
NOTE:
If battery is disconnected from system board for service, then there is a delay during system boot-up as the system
undergoes RTC battery reset.
Steps
1. Align and place the battery into its slot on the palm-rest assembly.
2. Tighten the three captive screws to secure the battery to the palm-rest assembly.
3. Connect the battery cable to its connector on the system board.
Next steps
1. Install the
base
cover.
2. Install the
microSD
card.
3. Install the
SIM
card.
4. Follow the procedure in
after working inside your
computer.
Removing and installing components
43
Advertisement
Table of Contents
