Steps
1. Slide the I/O board into the slots on the palm-rest and keyboard assembly.
2. Align the screw hole on the I/O board with the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
4. Connect the I/O-board cable to the connector on the I/O board and close the latch to secure the cable.
5. Adhere the tape that secures the I/O-board cable to the I/O board.
6. Connect the fingerprint reader-cable to the connector on the I/O board and close the latch to secure the cable.
7. Connect the coin-cell battery cable to the I/O board.
8. Close the left display hinge.
9. Replace the two screws (M2.5x5) that secure the left-display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Power button with fingerprint reader
Removing the power-button board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
heat
sink.
4. Remove the fan.
38
Removing and installing components
After working inside your
computer.
Before working inside your
computer.