Steps
1. Align the screw hole on the LED board with the screw hole on the palm-rest assembly.
2. Replace the (M2x3) screw to secure the LED board to the palm-rest assembly.
3. Route the LED-board cable and connect the cable to the connector on the system board.
4. Route the smartcard reader cable on the palm-rest assembly.
5. Connect the smartcard reader cable to the connector on the USH-daughter board and close the latch.
Next steps
1. Install the
assembly inner
2. Install the
3-cell battery
3. Install the
WWAN
card.
4. Install the
WLAN
card.
5. Install the
base
cover.
6. Install the
microSD
card.
7. Install the
SIM
card.
8. Follow the procedure in
frame.
or
4-cell
battery.
after working inside your
computer.
Removing and installing components
51