Dell Latitude 5530 Service Manual page 66

Steps
1. Flip the system board and connect the coin-cell battery cable to the connector on the system board.
2. Flip over and slide the system board to make the USB Type-C connector to toe-in to the hinge saddle and align the screw
holes on the system board with the screw holes on the palm-rest assembly.
3. Align and place the USB Type-C bracket on the system board.
4. Replace the three (M2x4) screws that secure the USB Type-C bracket to the system board.
5. Replace the three (M2x3) screws to secure the system board to the palm-rest assembly.
6. Route the coin-cell battery cable through the routing guide on palm-rest assembly and adhere the coin-cell battery on the
palm-rest assembly.
7. Connect the USH board cable to the system board and close the latch to secure the cable to the system board.
8. Connect the LED board cable to the system board and close the latch to secure the cable to the system board.
9. Connect the touchpad cable to the system board and close the latch to secure the cable to the system board.
10. Route the display and eDP cable through the routing guide on the system board.
11. Connect the eDP cable to the connector on the system board.
12. Connect the display cable to the connector on the system board.
13. Adhere the tape that secures the display cable to the system board.
66 Removing and installing components