13.6
Removing the passenger seat
13.7
Mounting the passenger seat
Main work
–
Push dust boots
Info
The dust boots remove dust and coarse dirt particles
from the inside fork tubes. Over time, dirt can accumu-
late behind the dust boots. If this dirt is not removed,
the oil seals behind can start to leak.
S04155-10
Warning
Danger of accidents Oil or grease on the brake discs
reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when nec-
essary.
–
Clean and oil the dust boots and inside fork tubes of both fork
legs.
Universal oil spray (
–
Press the dust boots back into the installation position.
–
Remove the excess oil.
Finishing work
–
Install the front fender. (
–
Take the motorcycle off the front lifting gear. (
–
Remove the rear of the motorcycle from the lifting gear.
(
p. 61)
–
Insert the ignition key in seat lock
–
Raise the rear of the seat, push it towards the rear, and lift it
off.
–
Remove the ignition key from the seat lock.
H01991-10
–
Attach hooks
on the subframe, and lower it at the rear while pushing for-
ward.
–
Press passenger seat downward until it clicks into place.
H01992-01
SERVICE WORK ON THE CHASSIS 13
1
of both fork legs downward.
p. 123)
p. 71)
1
and turn it clockwise.
1
on the passenger seat to seat mounting
p. 62)
2
63