Service Work On The Engine 19; Checking The Engine Oil Level; Changing The Engine Oil And Oil Filter, Cleaning The Oil Screens - KTM 390 ADVENTURE EU 2022 Owner's Manual

19.1

Checking the engine oil level

19.2

Changing the engine oil and oil filter, cleaning the oil screens

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Drain the engine oil while the engine is at operating temperature.
Condition
The engine is at operating temperature.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Check the engine oil level.
Info
After switching off the engine, wait one minute before
checking the level.
The engine oil must be between the
»
When the engine oil level is below the
A00688-10
–
Add engine oil. (
»
When the engine oil level is above the
–
Correct the engine oil level.
Preparatory work
–
Remove motor guard. (
–
Remove the engine guard retaining bracket. (
–
Stand the motorcycle on a level surface using the side stand.

SERVICE WORK ON THE ENGINE 19

A
and
A
p. 105)
B
p. 68)
B
markings .
marking:
marking:
p. 69)
103