16.1
Removing the 12-V battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep 12 V batteries out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks or open flames away from the 12 V battery.
–
Only charge 12 V batteries in well-ventilated rooms.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
16.2
Installing the 12-V battery
Preparatory work
–
Remove the passenger seat. (
–
Remove the front rider's seat. (
Main work
–
Remove screws
–
Disconnect negative cable
S04165-10
–
Pull back positive terminal cover
–
Disconnect positive cable
–
Unhook rubber strap
–
Pull the 12-V battery upwards and out of the battery compart-
ment.
Info
Never operate the motorcycle with a discharged 12-V
battery or without a 12-V battery. In both cases, elec-
S04166-10
trical components and safety devices can be damaged.
The vehicle will therefore no longer be roadworthy.
Main work
–
Position the 12-V battery in the battery compartment.
12-V battery (ETZ‑9‑BS) (
–
Close rubber strap
–
Position positive cable
–
Position positive terminal cover
S04166-11
ELECTRICAL SYSTEM 16
p. 63)
p. 64)
1
and take off the holding bracket.
2
from the 12-V battery.
3
.
4
from the 12-V battery.
5
and open rubber strap
p. 116)
1
and attach rubber strap
3
and mount and tighten the screw.
4
.
6
.
2
.
87