3
After water has been drained, tighten the valve and air bleeder plug.
If foreign material is adhering to the gauze filter in the cup, remove the cup, float and
4
gauze filter, and clean by blowing compressed air from the inside of the gauze filter.
Reassemble the gauze filter, cup and float to their original location.
5
< NOTE >
When attaching the cup, check that there is no foreign material adhering to the O-ring.
After attaching, open the fuel valve, and be sure to always start the engine and check that there is
no fuel leakage.
If water is accumulate in the cup, draining water from the fuel tank. (Refer to section "(6)
Draining Water from the Fuel Tank
Always be sure to wipe up any spilled fuel.
(5) Fuel Filter Replacement (Main and Pre-Filters)
Replace
Every 400 hours
Remove the fuel filter using a filter wrench.
1
Spread a thin layer of oil on a new fuel filter gasket.
2
Thread the fuel filter by hand, and turn by hand (do not use a
3
filter wrench) from when the gasket contacts the seal surface
until it is securely tightened.
Shortly after starting the engine, always be sure to check
4
that there is no fuel leaking from the seal surface.
< NOTE >
Be sure to wipe away any fuel that has spilled out of the piping when removing the filter.
Fuel filter part no.: Main filter 1K947-43171 (Kubota part no.)
Always be sure to wipe up any spilled fuel.
After attaching, be sure to always start the engine and check that there is no fuel leakage.
(6) Draining Water from the Fuel Tank
Drain Water
Every 200 hours
Set a container to catch spilled water.
1
Remove the fuel drain plug and packing (with rubber seal).
2
After the water has been drained, reinsert the fuel drain plug
with new packing (with rubber seal).
3
< NOTE >
Replace the packing of the fuel drain plug with new packing each time the water is drained.
Packing part no.: V106-000110
After reinserting the fuel drain plug, be sure to always check that there is no fuel leakage.
".)
Pre-filter 16631-43562 (Kubota part no.)
36
Gasket
Fuel Drain Plug
ぱっ