Table of Contents
Advertisement
< NOTE >
If measuring the output current for a single-phase three-wire type, turn the ammeter selector
switch to "L1+U" or "L3+W". The voltage cannot be accurately measured if set to "L2".
(3) Frequency Meter
Displays the frequency of the power source. Check that 60 Hz is displayed during operation.
Indicators
(1) Pre-heating Indicator
The pre-heating indicator lights up when the starter switch is at
PREHEAT. The pre-heating indicator turns off when
pre-heating is completed to indicate that it is possible to start
the generator.
< NOTE >
Pre-heating time depends on the coolant temperature, and
should be completed in approximately 0.5 to 15 sec.
(2) Pilot Lamp
This lights up when the engine is operating to indicate that
power is being generated.
Switches
(1) Starter Switch
STOP
The engine is stopped and all power is
cut off when in this position. The key
can be inserted and removed when in
this position.
RUN/PREHEAT
Position for operating the generator. It
is also the position for air heater
preheating
in
startability in cold condition.
< NOTE >
Do not leave the generator in this position with the engine stopped.
Doing so will cause the battery to drain.
START
Position where the engine is started. If you remove your hand from the key, the switch
automatically returns to RUN.
(2) Breakers
These switches are for transmitting electrical power to the load side. Turn to ON to output
voltage to the output terminals. Transmission of electricity to the load side is cut off when
there is a short circuit or overload on the load side.
< NOTE >
Do not operate these breakers to operate or stop a load.
order
to
increase
13
Pilot Lamp
Pre-Heating Indicator
Breaker Trip
Selector Switch
Ｓtarter
Ammeter
Switch
Selector Switch
3-Phase
1-Phase
Breaker
Breaker
Advertisement
Table of Contents
