Shindaiwa DGK60D Owner's Manual page 37

(1) Engine Oil Replacement
First Time
Thereafter Every 200 hours
1 Set a container to catch spilled engine oil.
Remove the oil filler cap.
2
After removing the oil drain plug and packing(a rubber
3
seal is attached),open the oil drain valve and drain the
engine oil.
After the oil has been drained,close the oil drain valve
4
and reinsert the oil drain plug with new packing
(a rubber seal is attached).
Add oil through the oil filler until it is at the maximum level while
5
checking the fuel level using the oil level indicator.
6
Attach the oil filler cap.
< NOTE >
 Refer to section "8-1. Checking Engine Oil" for engine oil
replacement amounts and types.
 Replace the packing of the oil drain plug with new packing each time the oil is replaced.
 Packing part no.: V106-000190
 After reinserting the oil drain plug and shortly after starting the engine, be sure to always check
that there is no oil leakage.
 Always be sure to wipe up any spilled engine oil.
(2) Replacing the Oil Filter
First Time
Thereafter Every 400 hours
Drain the engine oil. (Refer to section "1. Engine Oil Replacement".)
1
2 Remove the oil filter using a filter wrench.
Spread a thin layer of oil on a new oil filter gasket.
3
Thread the oil filter by hand, and turn by hand (do not use a
4
filter wrench) from when the gasket contacts the seal surface
until it is securely tightened.
Add engine oil to the generator.
5
Shortly after starting the engine, always be sure to check that
6
there is no oil leaking from the seal surface.
< NOTE >
 Request the authorized distributor where the generator was purchased to perform this procedure
if you do not have a filter wrench.
 Oil filter part no.: 1C020-32434 (Kubota part no.)
 Always be sure to wipe up any spilled engine oil.
50 hours
50 hours
34
Oil Level
Indicator
Oil Filler Cap
Oil Filler
Oil Drain plug
Packing
Open
Close
Oil Drain Valve
Oil Drain Plug
Gasket