Non Combustible Flush Finishing - Unit Assembly/Finishing/Mantel Clearances + Mantel Leg Clearances; Remove 8 Standoffs - Regency Greenfire GF1500LLP-2 Owners & Installation Manual

installation

Non Combustible Flush Finishing - Unit Assembly/Finishing/Mantel Clearances + Mantel Leg Clearances

Remove top nailing strips & standoffs at side and
underneath
Remove the top nailing strip/standoff by removing 4 screws in locations
shown in Diagram to the right, then lift off and recycle.
Break off the 8 standoffs with a pair of pliers.
Installation of Access Panel
The unit is equipped with a removable access panel for pre-finish installation
of optional components - this panel is located on the lower front face.
1. Remove 4 screws to remove access panel.
2. Easier access to gas connection with panel removed.
3. Install any optional components with access panel removed.
4. Reinstall access panel, line up 2 upper tabs and secure in place with
4 screws.
Note: Access panel is no longer usable/accessible once facing material
installed.
14 |
Greenfire® GF1500L-2 Gas Fireplace

Remove 8 standoffs

Tab locations on access panel
Installation Access Panel