Framing Dimensions - Regency Greenfire GF1500LLP-2 Owners & Installation Manual

installation

Framing Dimensions

IMPORTANT NOTE:
This unit can be finished with
combustible facing material
of thickness range 10-19mm
OR non-combustible facing
material of a minimum thick-
ness 12mm.
A
NOTE:
Do not place timber
studs below the timber fram-
ing studs already in place.
Additional steel studs must
be added as shown when
choosing the non combus-
tible flush finishing option.
D
Note: If raising the unit, then the
minimum framing height mea-
surement (A) must be adhered to.
For example: Unit raised 300mm
then A+ 300mm = 1240 mm.
10 |
Greenfire® GF1500L-2 Gas Fireplace
Framing
Description
Dimensions
A Framing Height
¹
Framing Height -Steel Stud
A
B Framing Width
C Framing Depth
D Minimum Height to Combustibles
E Corner Wall Depth
F Corner Facing Wall Width
G Vent Centerline Height
H* Non-combustible facing height
I Gas Connection Opening Height
J Gas Connection Height
K Gas Connection Inset
L Gas Connection Opening Width
NOTE: A minimum thickness of 12mm non-combustible facing board compliant with AS1530-1 and AS1530-3 is required
when using the non combustible flush finishing option.
A minimum thickness of 10mm-19mm combustible facing board is required when choosing the combustible flush finishing option.
Note: must maintain 13mm air gap all around the perimeter of the appliance when choosing this option.
Timber
Studs
B
C
Finished Floor
Combustible flush finishing Framing
Non-combustible Flush Finishing Framing
F
Timber
Studs
A
A
1
Steel Stud
on edge
B
Finished Floor
Note: Steel stud must be installed
after unit has been positioned in
place and prior to installation of
non- combustible finishing
GF1500
945 mm combustible finish
846 mm non combustible steel stud
1394 mm
568 mm
1225 mm
1460 mm
2065 mm
1016 mm
*see non-combustible facing height in this manual
38 mm
67 mm
44 mm
89 mm
Drywall or
other facing
Header
H
Non-Combustible
Facing
C
C
C
J
K
G
I
L