13
BRAKE SYSTEM
13.8
Adjusting the basic position of the foot brake lever
Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
(Duke R)
–
Disconnect spring
–
Move the foot brake lever back and forth between the end stop and the contact to
the foot brake cylinder piston and check free travel
Guideline
Free travel at foot brake lever
»
If the free travel does not equal the specification:
–
V00567-10
–
Attach spring
(Duke)
–
Disconnect spring
–
Remove screw
–
Loosen nut
free travel is reached.
–
To adjust the basic position of the foot brake lever to individual requirements,
loosen nut
V00061-10
1
.
Adjust the basic position of the foot brake lever.
1
.
1
.
6
.
4
and turn it back with ball joint
2
and turn screw
3
accordingly.
A
.
3... 5 mm (0.12... 0.2 in)
(
p. 107)
5
until the maximum amount of
107