19
CLEANING, CARE
–
Seal the exhaust system to keep water out.
–
First remove coarse dirt particles with a gentle spray of water.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a brush.
Motorcycle cleaner (
Info
Use warm water containing normal motorcycle cleaner and a soft sponge. Never
apply motorcycle cleaner to a dry vehicle; always rinse the vehicle with water
first.
401061-01
If the vehicle was operated in road salt, clean it with cold water. Warm water
enhances the corrosive effects of salt.
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Remove the closure of the exhaust system.
Warning
Danger of accidents Moisture and dirt impair the brake system.
–
–
After cleaning, ride the vehicle a short distance until the engine warms up.
Info
The heat produced causes water at inaccessible locations in the engine and on
the brake system to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. (
–
Treat bare metal parts (except for brake discs and exhaust system) with anti-corrosion
materials.
p. 197)
Brake carefully several times to dry out and remove dirt from the brake lin-
ings and the brake discs.
p. 88)
170