Electronic Unit Holder Removal; Electronic Unit Removal (Integrated) - Miele G2000 Technical Information

G1000 / G2000 Dishwashers
5.5.2

Electronic Unit Holder Removal

1. Door outer panel removal (5.2.3).
2. Fascia panel removal (5.2.4).
3. Remove the screws from the sides of the door inner panel.
4. Remove the door contact switch retaining screw.
5. Disconnect all plug connections at the electronic unit.
6. Remove the holder with electronic unit.
7. Remove the lock with door contact switch.
5.5.3

Electronic Unit Removal (Integrated)

1. Fascia panel removal (5.2.3).
2. Pull out the switch buttons.
Note
If the dishwasher has a slanted fascia, the door outer panel must be
removed, see Door outer panel removal, 5.3.1.
3. Remove the screws from the sides of the door inner panel.
4. Remove the middle screw from the top of the door inner panel.
5. Tilt the holding plate to the front.
Note
If the dishwasher has a furniture front, take care to insert a towel or
similar between its top edge and the fascia to prevent the risk of
scratching.
6. Disconnect all plugs.
7. Use a small screwdriver to press in all the retaining lugs (6) of the electronic unit
on the holding plate (first at the bottom and then at the top).
8. Remove the electronic unit.
Note
Only the complete electronic unit can be exchanged.
Note
Take care with the following during reassembly:
The fascia must be fitted before the switch buttons are refitted.
Ensure the switch buttons are fitted correctly. The bottom is
recessed.
105
Technical Information