Table of Contents
Advertisement
G1000 / G2000 Dishwashers
Function
Pos. 0:
Do not press the Gel button. The
Software
Gel LED is off.
version ID
check
Pos. 1: Fault
Press the Gel button once. The Gel
memory display
LED flash
and deletion
intermittently. Press the program
button. Press it again to display fault
codes that may have been saved.
To delete the fault memory, press
the program button again and hold
it until F and 0 are shown alternately
Pos.2:
Press the Gel button 2 times. The
Component
Gel LED flashes 2 times rapidly
test
intermittently. Press the program
button. Press it again to activate the
next component.
Pos 3: Vacant When the decimal point in the
display has switched off after
approx. 6 sec., press the Gel button
3 times. The Gel LED flashes 3
times rapidly intermittently. Press
the program button.
Pos 4:
Press the Gel button 4 times. The
Operating
Gel LED flashes 4 times rapidly
hours check
intermittently.
Pos. 5.1: LED
Press the Gel button 5 times. The
test
Gel LED flashes 5 times rapidly
intermittently. Press the program
button.
Pos. 5.2:
Press the Gel button 5 times. The
Buzzer test
Gel LED flashes 5 times rapidly
intermittently. Press the program
button 2 times.
Pos. 6: Vacant Press the Gel button 6 times. The
Gel LED flashes 6 times rapidly
intermittently. Press the program
button.
Table 6-43: G1470 / G2470 Service Mode Options
Quit (without saving)
Switch off the unit.
Programming
es once rapidly
169
Display
The display shows the software
version ID No., e.g. -769
The display shows F and a fault code
number alternately, see 6.7, Fault
code summary. If the fault memory is
empty, F and 0 are displayed
alternately.
The display shows F and 0 alternately.
The display shows which component
is being tested: For example if the
drain pump M8 is being tested, U and
3 are shown alternately. For the test
sequence and background information
about individual components and their
activation, see 6.4.2.3, Component
test.
The display shows = 0
The display shows the number of
operating hours as follows: If the
machine has run for 74 hours, H, 7
and 4 are displayed alternately.
The display shows 6.1: All LEDs are
lit.
This display shows 6.2: The buzzer is
activated.
The display shows C0.
Technical Information
Advertisement
Table of Contents
