Table of Contents
Advertisement
Installation
Installation
Damage caused by condensation.
In order to reduce the risk of damage
from condensation, the cabinetry in the
area around the dishwasher should be
designed for commercial use.
Only use cabinetry that is designed for
commercial use.
The dishwasher must be stable and hori-
zontal. Any unevenness in the floor level and
height of the machine can be compensated
for by adjusting the four feet.
The machine height can be adjusted from
32 5/16"-34 5/8" (820–880 mm) using the
machine feet. Dishwashers with lids have an
additional 9/16" (15 mm) in height.
The front machine feet can be adjusted with
a wrench (wrench size 13); the rear ones can
be adjusted with a T20 Torx screw.
If the runners of the rear machine feet are
not installed, the machine feet can also be
adjusted with the wrench.
They are adjusted upward when turned
clockwise and downward when turned
counterclockwise.
If the dishwasher is to be installed next to
other machines and cabinetry or in a recess,
an installation space measuring at least 23
5/8" (600 mm) in width and 23 5/8"
(600 mm) in depth is required.
Dishwashers with active drying require a
space measuring 22 3/4" (580 mm) in
depth.
100
Undercounter installation
Risk of the machine tipping.
To ensure stability, an undercounter dish-
washer must only be installed beneath a
continuous countertop that is bolted to
the adjacent cabinetry.
Install the dishwasher underneath a
bolted continuous countertop.
If the dishwasher is to be installed beneath
a continuous countertop, an installation
space measuring at least 23 5/8" (600 mm)
wide, 23 5/8" (600 mm) deep, and 32 5/16"
(820 mm) high is required.
Dishwashers with active drying require an
installation space measuring 22 3/4"
(580 mm) in depth.
Dishwashers with a plinth return are sup-
plied with a toe-kick filler panel. This can be
installed instead of a toe-kick board.
When adjusting the dishwasher height,
the feet must not be unscrewed by more
than 2 3/8" (60 mm).
Hose holder
The supplied hose holders can be used to
lay the power cord and the hoses for supply
and waste water in a way that saves space.
The hose holder prevents hoses from kink-
ing or crushing when installing the machine
in tight recesses.
The power cord and hoses can be laid ei-
ther on the left or the right, depending on
the connection situation.
Advertisement
Table of Contents
