6855 Remote Annunciator Installation
Surface Mounting
The optional Model RA-100TR Trim Ring Kit is available for use when surface mounting.
1.
Remove the desired knockout.
2.
Mark and pre-drill hole in the wall for the center top keyhole mounting bolt. Refer to Figure 4.14 for mounting hole locations.
3.
Install center top fastener in the wall with the screw head protruding.
4.
Place backbox over the top screw, level and secure.
5.
Mark and drill the left and right upper and lower mounting holes.
6.
Install remaining fasteners and tighten.
7.
Run wires to the control panel. Refer to Figure 4.3.
8.
Place the trim ring over the back box as shown below.
9.
Attach the door assembly to the backbox using the screws provided. Refer to Figure 4.15.
6700 Manual — P/N LS10148-001SK-E:F 8/29/2022
Figure 4.15 Attaching Annunciator/Door Assembly to Backbox
Figure 4.16 Installing Trim Ring
Control Panel Installation
33