Honeywell SILENT KNIGHT 6700 Manual page 36

Control Panel Installation
Surface Mounting
The 5860 can be mounted directly to a surface or can be attached to a single, double, or four-square electrical box. Trim Ring Kit 5860TR/G
is available for use when surface mounting.
1. Drill holes in the surface to match the screw holes on the backbox. Refer to Figure 4.20 for locations.
2. Fit the trim ring over the backbox.
3. Attach the backbox to the wall using screws provided.
4. Wire the annunciator to the FACP as shown below.
supervised,
power-limited,
5. Replace the electronic assembly in the backbox. Place the bezel over the backbox and tighten the set screws on the bezel. Refer to
Figure 4.20 for location of set screws.
36
Insert wires at an angle into the first holes past sheetrock.
Figure 4.21 Flush Mounting the Backbox
Class B
Figure 4.22 5860 Connection to the Panel
Attach second set of wires to top of backbox.
Secure wires behind screw.
6700 Manual — P/N LS10148-001SK-E:F 8/29/2022
5860 Remote Annunciator Installation