Fitting The Stability Bracket Or Chain - Rangemaster Classic Deluxe User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.
Fig. 10.5
Fig. 10.6
ArtNo.010-0004 Moving the cooker
Fig. 10.7
Fig. 10.8
Stability chain
Fig. 10.9
Alternative positions
for stability location
bracket
INSTALLATION
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(Fig. 10.5). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the cardboard base tray. Open the
oven doors so that you can get a good grip on the bottom of
the fascia panel as you move the oven (Fig. 10.6).
Carefully push the cooker backwards off the base tray.
Remove the base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it Fig. 10.7).
DO NOT use the door handles or control knobs to
n n
manoeuvre the cooker.
Fitting the Stability Bracket or
Chain
Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig. 10.8 and Fig. 10.9.
If you are using a stability chain (Fig. 10.8) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
If you are using a stability bracket; first attach the bracket
location device to the rear of the cooker (Fig. 10.9). Then
adjust the bracket to engage through the slot of the device
(Fig. 10.10 and Fig. 10.11).
34