Moving The Cooker; Fitting The Stability Bracket Or Chain - Rangemaster Classic 110 Dual Fuel Lidded User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.

Moving the Cooker

On no account try and move the cooker while it is
n n
plugged into the electricity supply.
The cooker is very heavy, so take great care.
n n
We recommend that two people manoeuvre the cooker.
Make sure that the floor covering is firmly fixed, or removed,
to prevent it being disturbed when moving the cooker
around.
To help you, there are two levelling rollers at the back, and
two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt
the cooker backwards and remove the front half of the
polystyrene base (Fig.7.5). Repeat from the back and remove
the rear half of the polystyrene base.
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig.7.6). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the cardboard base tray. Open the
grill door and right-hand oven door so that you can get a
good grip on the bottom of the fascia panel as you move the
oven (Fig.7.7).
Carefully push the cooker backwards off the base tray.
Remove the base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
DO NOT use the door handles or control knobs to
n n
manoeuvre the cooker.

Fitting the Stability Bracket or Chain

Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig.7.8, Fig.7.9 and
Fig.7.10.
If you are using a stability chain (Fig.7.8) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
If you are using a stability bracket (Fig.7.9 and Fig.7.10), then
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
INSTALLATION
Stability bracket
Wall
21
ArtNo.010-0004 Moving the cooker
Stability chain
3 mm min
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical floor mounting
Typical oor mounting
Outer stability
bracket
3 mm min
Typical wall mounting
Typical wall mounting
Fig.7.6
Fig.7.7
Fig.7.8
Fig.7.9
Cooker
Floor
Fig.7.10
Cooker
Floor