Completing The Move; Fitting The Stability Bracket Or Chain; Repositioning The Cooker Following Connection - Rangemaster Classic 110 Gas User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut ( ). Rotate the nut – clockwise to raise – counter-
Fig.7.5
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.

Completing the Move

Unfold the rear edge of the cardboard base tray. Open the
grill door and right-hand oven door so that you can get a
good grip on the bottom of the fascia panel as you move the
oven ( ).
Fig.7.6
Carefully push the cooker backwards off the cardboard base.
Remove the base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
DO NOT use the door handles or control knobs to
n n
manoeuvre the cooker.

Fitting the Stability Bracket or Chain

Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in
.
Fig.7.9
If you are using a stability chain (
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
If you are using a stability bracket (
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Repositioning the Cooker Following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
( ); you need to check behind the cooker to make sure
Fig.7.6
that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the cooker to
move.
With a stability chain fitted, release it as you ease the cooker out.
Do not forget to refit it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
INSTALLATION
, and
Fig.7.7 Fig.7.8
) then the chain
Fig.7.7
and ), then
Fig.7.8 Fig.7.9
Stability chain
Stability bracket
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical floor mounting
Outer stability
bracket
Wall
Typical wall mounting
Typical wall mounting
25
Cooker
3 mm min
Typical oor mounting
Cooker
3 mm min
Floor
Fig.7.5
Fig.7.6
Fig.7.7
Fig.7.8
Floor
Fig.7.9