Fitting The Stability Bracket Or Chain; Repositioning The Cooker Following Connection; Conversion To Another Gas; Levelling - Rangemaster Elite SE 110 User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.

Fitting the Stability Bracket or Chain

Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig.8.7, Fig.8.8 and
Fig.8.9.
If you are using a stability chain (Fig.8.7) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
If you are using a stability bracket (Fig.8.8 and Fig.8.9), then
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Repositioning the Cooker Following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig.8.6), you need to check behind the cooker to make sure
that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the cooker to
move.
With a stability chain fitted, release it as you ease the cooker out.
Do not forget to refit it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.

Conversion to Another Gas

If the appliance is to be converted to another gas do the
conversion at this point. See the conversion section of these
instructions.

Levelling

You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front turn the feet bases to raise or lower.
INSTALLATION
Stability bracket
25
Stability chain
3 mm min
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical oor mounting
Outer stability
bracket
3 mm min
Wall
Typical wall mounting
Fig.8.7
Fig.8.8
Cooker
Floor
Fig.8.9
Cooker
Floor