Adjusting The Height On A Multiline Terminal; Figure 4-15: Locating The Adjustment Tabs On The Multiline Terminal; Figure 4-16: Raising The Height On The Dterm Series I Multiline Terminal; Figure 4-17: Lowering The Base Plate On The Multiline Terminal - NEC Xen alpha Installation Manual

S 8
E C T I O N
The base plate on the D
the terminal to be raised or lowered.
A
DJUSTING THE
H
EIGHT ON A
1.
M
ULTILINE
T
ERMINAL
2.
3.
4.
98
term
Turn the Multiline Terminal upside down and locate the tabs (marked A).

Figure 4-15: Locating the Adjustment Tabs on the Multiline Terminal

Grasp in the middle of the hollow spaces at the top and pull up until the retaining
tabs click to raise the base plate. Refer to Figure 4-16: Raising the Height on the
Dterm Series i Multiline Terminal.

Figure 4-16: Raising the Height on the Dterm Series i Multiline Terminal

Once the height been adjusted, the line cord can be adjusted by pulling the line
cord though the groove in the bottom of the Multiline Terminal.
To lower the base plate on the Multiline Terminal, push on the adjustment tabs on
the side of the stand and push the base plate downward.

Figure 4-17: Lowering the Base Plate on the Multiline Terminal

Installation Manual, Chapter 4 – Installing Dterm Series i Multiline Terminals
Series i Multiline Terminal is hinged to allow the height of
A6-506000-642-01(8508), Release 6.0, November 2003