Wall Mounting; Removing And Remounting The Handset Hanger; Wall Mounting, Using The Base Unit; Figure 6-15: Lowering The Base Plate On The Multiline Terminal - NEC Xen alpha Installation Manual

4.
S 8
E C T I O N
Any DTU-Type Multiline Terminal can be mounted on a wall. Multiline Terminals can be
wall mounted by using the base unit that comes with the Multiline Terminal or
W
ALL
by using the WMU-UA Unit to accommodate adapters that are installed on the
M
OUNTING
Multiline Terminal.

Removing and Remounting the Handset Hanger

1.
2.

Wall Mounting, Using the Base Unit

1.
2.
3.
134
To lower the base plate on the Multiline Terminal, push on the adjustment tabs and
push the base plate downward.

Figure 6-15: Lowering the Base Plate on the Multiline Terminal

Remove the hanger by sliding it out of the slot.
Install it back in its original position so that the hanger protrudes providing a rest
for the handset. (This procedure applies when using either the base unit or the
WMU-UA Unit.) Refer to Figure 6-16: Positioning the Handset Hanger for the
steps for removing and remounting the handset hanger.

Figure 6-16: Positioning the Handset Hanger

Refer to
Section 9: Preparing Multiline Terminal for Adapter Installation
Steps 1 – 5.
Press both sides of the base cover and turn it left to remove it.
Rotate base cover 180° and install it again on the Multiline Terminal.
Installation Manual, Chapter 6 – Installing DTU-Type Multiline Terminals
, and perform
A6-506000-642-01(8508), Release 6.0, November 2003