Figure F-10 Zoning For Front-Mounted Twin Propellers (Low- Or High-Wing - Garmin GI 275 Installation Manual

F.2.2.2 Aircraft with Multiple Propellers
Zoning of low- or high-wing aircraft with twin front-mounted propellers is shown in Figure F-10. The text
below assumes the aircraft fuselage and wing are constructed of metal. Note that Zone 2A can overlap onto
the nacelles if they are within 0.6 meters outboard of the fuselage.
Zoning of low- or high-wing aircraft with rear-mounted twin propellers is shown in Figure F-11. The text
below assumes the aircraft fuselage and wing are constructed of metal.
For an empennage with a third engine, the GTP 59 cannot be located in the empennage. Therefore, the
zoning for this third engine area has been omitted from the diagrams below. The GTP 59 for this aircraft
should be located in Zone 3 or Zone 2A on the bottom of the fuselage and wings.

Figure F-10 Zoning for Front-Mounted Twin Propellers (Low- or High-Wing)

190-02246-14
Rev. 11
A
B
GI 275 STC EIS & MFD Installation Manual
Page F-12