Figure 5-2 Entering The Configuration Menu; Entering Configuration Mode - Garmin GI 275 Installation Manual

5.1.1

Entering Configuration Mode

The Configuration mode of the GI 275 can be accessed by holding down the inner knob, located at the
bottom-left of the unit, upon initial power-up. The knob must be held until the Garmin logo with
"Configuration Mode" below it appears. For installations with multiple GI 275s, all other units can be
easily powered on in Configuration mode by navigating to the Restart Options page from the
Configuration mode home page on one unit and touching the Restart All to Config button.
NOTE
When making configuration selections on the GI 275, in many cases, there is no dedicated
Enter selection. The selections made are confirmed by touching the Back button to exit the
particular screen/page.
NOTE
When powering on the GI 275 in Configuration mode for the first time, a Unit ID must be
assigned before any configuration settings can be changed. Refer to Section 5.3.1.
190-02246-14
Rev. 11

Figure 5-2 Entering the Configuration Menu

GI 275 STC EIS & MFD Installation Manual
Page 5-4