Table 5-5 Eis/Gea Configuration Settings; Table 5-6 Engine Annunciator Configuration Settings; Eis - Garmin GI 275 Installation Manual

5.5.12 EIS

Configure the EIS per the settings for EIS 1 or EIS 2 (if equipped) in Table 5-5. For twin-engine EIS, EIS 1
must be configured as left or front engine and EIS 2 must be configured as right or rear engine.
For twin-engine EIS, the first GI 275 display should have EIS 1 configured according to Table 5-5 and EIS
2 configured as Other GI 275. The second GI 275 display should have EIS 1 configured as Other GI 275
and EIS 2 configured according to Table 5-5.
EIS
GEA 24
EIS from
other GI 275
Notes:
[1] Annunciations are required if the GI 275 EIS is installed outside of 35° of the centerline. Refer to
Section 4.3.3 for installation information. Refer to Table 5-6 for configuration settings.
5.5.12.1 Engine Annunciator
Configure the Engine Annunciator Interface per the settings in Table 5-6. In multi-engine aircraft and in
single-engine aircraft with two EIS displays, only configure the annunciator discretes on EIS 1. Configure
the annunciator discretes on EIS 2 as None.

Table 5-6 Engine Annunciator Configuration Settings

Aircraft
System
LED-40-17-BA2-E1WP6
28V
MS25041
95-40-17-B4-E1WPN
14V
MS25041
190-02246-14
Rev. 11

Table 5-5 EIS/GEA Configuration Settings

Interface
RS-232
GEA 24
Annunciations [1]
Other GI 275 Annunciations [1]
Engine Annunciator
Ports/Config - Settings
Engine Caution
Discrete Out Lo
1 Thru 9
GI 275 STC EIS & MFD Installation Manual
Port Numbers
1 Thru 2
Engine Warning
Discrete Out Lo
1 Thru 9
Page 5-15