Figure B-12 Traffic Advisory System Interconnect - Garmin GI 275 Installation Manual

NOTES
FOR HONEYWELL TRAFFIC SYSTEMS, DO NOT SPLICE "TAS TEST" OR "TIS/TAS STANDBY".
1
TAS TEST AND TIS/TAS STANDBY DISCRETE CONNECTIONS ARE ONLY REQUIRED IF THE GI 275 IS
INTERFACED USING ARINC 429 AND CONFIGURED FOR "CONTROL TRAFFIC". DISCRETE CONNECTIONS
2
ARE NOT REQUIRED FOR HSDB CONNECTION.
FOR THE TCAD TO ACCEPT ARINC 429 HEADING AND ALTITUDE, PROCESSOR P/N 70-2420-5 OR LATER IS
3
REQUIRED. THE BUS SPEED MUST BE THE SAME FOR ARINC 429 RX 1 AND RX 2.
REFER TO SECTION 3.2.5 FOR HSDB ARCHITECTURE.
4
USE ONLY AHRS OR ADAHRS OUTPUT OF GSU 75.
5
USE ONLY ADC OUTPUT OF THE GSU 75.
6
IF DESIRED, ALTITUDE AND HEADING MAY BE PROVIDED BY THE GI 275 TO THE SKYWATCH SYSTEM. ANY
AVAILABLE ARINC 429 INPUTS ON THE TRAFFIC COMPUTER MAY BE USED IF THOSE SHOWN ARE
ALREADY USED. THE TRAFFIC SYSTEM MAY HAVE TO BE CONFIGURED TO ACCEPT ALTITUDE AND
7
HEADING VIA ARINC 429 (LOW-SPEED). REFER TO THE MANUFACTURER'S INSTALLATION MANUAL FOR
ADDITIONAL INFORMATION.
IF DESIRED, ALTITUDE, ATTITUDE, AND HEADING MAY BE PROVIDED BY THE GI 275 TO THE HONEYWELL
TRAFFIC SYSTEM. THE HONEYWELL TRAFFIC SYSTEM WILL NOT ACCEPT HEADING/ATTITUDE AND
ALTITUDE ON A SINGLE ARINC 429 INPUT. CONSEQUENTLY, HEADING/ATTITUDE (HIGH-SPEED) AND
8
ALTITUDE (LOW-SPEED) MUST BE PROVIDED TO SEPARATE INPUTS. THE TRAFFIC SYSTEM MUST BE
CONFIGURED TO ACCEPT ARINC 429 ALTITUDE, HEADING, AND ATTITUDE. REFER TO THE
MANUFACTURER'S INSTALLATION MANUAL FOR ADDITIONAL INFORMATION.
IF DESIRED, ALTITUDE, TEMPERATURE, HEADING, SPEED, AND SELECTED COURSE INFORMATION MAY
9
BE PROVIDED BY THE GI 275 TO THE TRANSPONDER.
IF THE GI 275 IS THE ONLY ALTITUDE SOURCE FOR THE GTX, IT IS RECOMMENDED THAT THE GTX ALSO
BE CONNECTED DIRECTLY TO AN EXTERNAL AIR DATA SOURCE SO THAT THE TRANSPONDER WILL
10
CONTINUE REPORTING ALTITUDE IN THE EVENT OF A GI 275 FAILURE.
IF ANOTHER TRAFFIC SOURCE IS WIRED TO THE GI 275, DO NOT WIRE THE GTX ARINC OUTPUT TO THE
11
GI 275.
DO NOT WIRE TO THE GI 275 IF A GTX 345 IS INSTALLED. THESE TRAFFIC SYSTEMS MUST BE WIRED IN
12
ACCORDANCE WITH THE GTX 345 INSTALLATION MANUAL FOR PROPER CORRELATION AND DISPLAY.
TRC 497 SOFTWARE v1.6 OR HIGHER IS REQUIRED.
13

Figure B-12 Traffic Advisory System Interconnect

190-02246-14
Rev. 11
Sheet 2 of 3
GI 275 STC EIS & MFD Installation Manual
Page B-23