Set The Separator Gap - Pitney Bowes ADDRESSRIGHT DA750 Operator's Manual
Pitney bowes inc. all in one printer user manual
Hide thumbs
Also See for ADDRESSRIGHT DA750:
- Quick reference manual (2 pages) ,
- Operating manual (143 pages)
Table of Contents
Advertisement
Setting Up A Job
(continued)
SV61027 Rev. D
DA700/DA750 Features and Adjustments • 3
1. Set the Separator Gap
Whenever you switch from one material type to another, you
need to set the gap between the separators and the feed
roller before printing begins.
NOTE: There are three positions of the "H" Blocks.
•
Lever fully down - adjusted to media thickness (ready
to operate).
•
Lever midpoint - not adjusted to any media (free
floating on media, not set up to operate).
•
Lever fully up - locked in the up position, not adjusted
to any media thickness.
Setting the Proper Feed Gap
1. Loosen the lock knobs to unlock all three H-Blocks.
2. Lift the H-Blocks to their highest position and lock in
place.
3. Place a sample piece of material between the sepa-
rator fingers (the lower section of the H-Blocks) and
the feed roller.
H-Blocks
3-9
Advertisement
Table of Contents
