Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Main unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20
Total pedestal adjustment . . . . . . . . . . . . . . . . . . . . . . .28
Introduction
O This multi-function controller is used to control one or
more pan-tilt head systems (each of which consists of a
pan-tilt head and convertible camera) and at the same
time provide video signal cable compensation.
It consists of a main unit which processes the signals and
a control panel for operating the pan-tilt head system or
systems, and these two parts are connected by the
connecting cable (10 m) supplied.
O Up to three control panels can be connected to the main
unit.
The cable supplied with the control panel and a 10BaseT
straight cable (UTP category 5) are used for the
connection.
A headset for inter-communication purposes can be
connected to the control panel to enable communication
between the control panels.
Accessories
Connecting cable (10m) . . . . . . . . . . . . . . . . . . . . . . . . . .1
Intercom jack (M6 jack) . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Plug (Mini DIN 6-pin) for inter-communications
system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Use the dedicated AC adapter (AW-PS505) for the power supply.
When the AW-PS505 is used as the power source, 4 additional AW-PB605 boards (optional accessory) can be
installed in this unit, making it possible to use up to 5 video boards in total.
Note that when any optional boards are installed, the AJ-B75 AC adapter (optional accessory) should be used if
the total power consumption, including that of this unit, exceeds 30 W.
Setting menus . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .36
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .43
O Up to five pan-tilt head systems can be connected to the
main unit, and composite systems or component systems
can be supported.
However, when a component system is to be supported,
the AW-PB302 RGB card (optional accessory) must be
installed in the convertible camera.
O When the AW-PH350 is used as the pan-tilt head, the
connection between the main unit and pan-tilt head
system can be extended up to 1,000 meters.
When any other pan-tilt head model is used, it can be
extended up to 800 meters.
<Note>
The camera function cannot be controlled when the
AW-PH500 is used.
Rack mounting adapters (5U) . . . . . . . . . . . . . . . . . . . . .4
Mounting screws (M4a8 mm) . . . . . . . . . . . . . . . . . . . . .8
3