Main Unit - Panasonic AW-RP605 Operating Instructions Manual

Parts and their functions

$ Main unit

EXT/
SERVICE
REMOTE
1 POWER lamp
This lights up green when power is supplied to the main
unit and the DC POWER switch is set to ON. It goes off
when the switch is set to OFF.
2 DC POWER switch
This is the main unit's power switch.
3 DC 12V IN socket
The AW-PS505 AC adapter (optional accessory) is
connected to this socket.
When the AW-PS505 is used as the power source, 4
additional AW-PB605 boards can be installed in this unit,
making it possible to use up to 5 video boards in total.
Note that when any optional boards are installed, the AJ-
B75 AC adapter (optional accessory) should be used if
the total power consumption, including that of this unit,
exceeds 30 W.
4 CONTROL PANEL POWER OUT socket
The power for the control panels is output from this
socket.
The socket is connected to the DC 12V IN socket on the
control panel using the connecting cable (10 meters)
supplied.
<Notes>
O When the connection distance exceeds 10 meters,
connect the AW-PS505 AC adapter (optional
accessory) to the control panel instead of the
connecting cable supplied.
O When more than one control panel is to be connected,
connect the AW-PS505 AC adapter (optional
accessory) to an additional control panel.
G/L
IN
75Ω
AUTO
AUX
IN
75Ω
PREVIEW
MONITOR
OUT 1
PREVIEW
MONITOR
OUT 2
PREVIEW
MONITOR
OUT 3
5 4 3 2
5 4 3 2 1
CONTROL OUT
TALLY
TO PAN/TILT HEAD
TO PAN/TILT
HEAD
VIDEO
/Y
IN
Pr
IN
Pb
IN
OPTION
CARD
G/L
OUT
- +
VIDEO
1 4
/Y
2 3
OUT
Pr
OUT
Pb
OUT
CONTROL PANEL
TERMINATION
TALK - + TALK
6 5
4 3
2 1
OFF ON
RECEIVE - + RECEIVE
1 EXTERNAL 3 2
INCOM
CONTROL
CONTROL IN
OUT
TO CONTOROL PANEL
7 6 5
5 CONTROL IN TO CONTROL PANEL connectors
[1] to [3]
The control signals are input from the control panels to
these connectors. Use the connecting cable (10 meters)
supplied to connect the connectors to the CONTROL
OUT connectors on the control panels.
<Note>
If the connection distance exceeds 10 meters, use a
straight cable equivalent to 10BaseT (UTP category 5) to
make the connection. The connection distance can be
extended up to 1,000 meters.
When more than one control panel is to be connected to
the main unit, make sure that the total length of all the
cables does not exceed 1,000 meters.
6 TERMINATION switch
This is the control signal termination switch.
<Notes>
O When one control panel is connected to the main unit,
set both this switch and the TERMINATION switch on
the control panel to the ON position.
O When two control panels are connected to the main
unit, set this switch to the OFF position, and set the
TERMINATION switches on the control panels to the
ON position.
O When three control panels are connected to the main
unit, set this switch and the TERMINATION switch on
the control panel with the shortest connecting cable to
the main unit to the OFF position, and set the
TERMINATION switches on the other two control
panels to the ON position.
7 EXTERNAL CONTROL OUT connector
This connector is intended to support additional functions.
It is not supported at the present time.
12
PO W ER
1
DC POWER
ON
2
OFF
3
DC 12V IN
PUSH
GND
4
POWER OUT
1