Configure The Alarm Action Settings [Event Setup] - Panasonic WJ-RT416 Installation Manual

Configure the alarm action settings [Event Setup]

Configure the settings relating to the alarm action that is to be taken at an event occurrence.
Refer to page 27 for further information about the event type and the alarm action.
Event Setup
Common Setup
Alarm Rec. Setup
q Configure the common settings for the alarm recording [Common Setup]
Configure the common settings relating to the alarm action that is to be taken when an event (terminal alarm, VMD alarm, com-
mand alarm) occurred.
Common Setup
Alarm Buzz
Alarm Spot
Pre Alarm Recording
OK
I Alarm Buzz
Select "On" or "Off" to determine whether or not to sound the
buzzer at an event occurrence. The selected duration for
"Alarm Duration" of "Alarm Rec. Setup" ( page 59) will be
applied as the sounding duration of the buzzer.
On: Sound the buzzer
Off: Do not sound the buzzer
Default: On
I Alarm Spot
Select "On" or "Off" to determine whether or not to display
images from the camera that is selected for "Alarm Spot
Camera No." of "Alarm Rec. Setup (Advance)" ( page 59)
on a single screen at an event occurrence.
On: Display images from the selected camera.
Off: Do not display images from the selected camera.
Default: On
Note:
The screen that was displayed immediately before an
event resumes after the event is finished.
58
q
w
On
On
Off
Cancel
I Pre Alarm Recording
Select "On" or "Off" to determine whether or not to start
recording from the specified seconds before an event
occurrence (pre-alarm recording).
On: Start the pre-alarm recording.
Off: Do not start the pre-alarm recording.
Default: Off
Notes:
• Maximum recording duration of the pre-alarm recording
is approximately 5 seconds. Recording duration of the
pre-alarm recording varies depending on the following
settings.
• I Frame Interval
• Capture Resolution
• Rec. Quality
• Rec. Frame Rate
• Audio is not recorded during pre-alarm recording.