Connection; Basic Connection - Panasonic WJ-RT416 Installation Manual

Connection

Basic connection

Combination cameras (VIDEO IN 1 - 4)
Important:
• When connecting an external recording device, use an optional USB cable to connect it to the COPY1 port on the rear or to
the COPY2 port on the front of the recorder.
• Transmission loss of video signals from the cameras connected to the VIDEO IN 1-8 connectors (VIDEO IN 5-8 connectors
are available only when an optional board is installed) can be compensated by selecting a proper value for the cable com-
pensation setting (Comp.).
S: Suitable when the total cable length between the camera and the recorder is shorter than 500 m
M: Suitable when the total cable length between the camera and the recorder is 500 – 900 m
L: Suitable when the total cable length between the camera and the recorder is 900 – 1 200 m
• Use 5C-2V cable to connect between the recorder and the camera.
• Select a proper value for the cable compensation setting (Comp.) according to the actual length of the cable in use.
Otherwise, images from the camera will not be displayed/recorded correctly.
• Audio signal from a microphone should be supplied to the recorder after amplifying to line level (–10 dBv, 51 kΩ) by an
amplifier.
42
SEQUENCE SEARCH
HDD
1
1 2 3 4
SETUP COPY
ERROR
2
ALARM
MULTI
5 6 7 8
3 SCREEN
TIMER
4
9 10/0 11 12
5 ESC
ALARM
RESET
OPERATE
SET
6
13 14 15 16
System cameras (VIDEO IN 5 - 16)
Connect the cables from
the microphone amplifier to
the AUDIO IN connectors.
STOP PLAY PAUSE REC REC STOP
Connect the video
REV FWD SKIP
monitor to the
– +
monitor 1 connector.
Digital Disk Recorder WJ-RT416
Microphones
Amplifier
Video monitor
External recording device
connected to the COPY1
(rear) or COPY2 port (front)