Panasonic WJ-RT416 Installation Manual page 59

w Configure the alarm recording settings [Alarm Rec. Setup]
Configure the settings relating to the alarm recording that starts upon an event occurrence.
Alarm Rec. Setup
Alarm No.
00:00 24:00
Term
Rec. Channel
00:00 24:00
VMD
Rec. Channel
Sensitivity
Area Setup
Advanced Setup
All
I Alarm No.
"Alarm No." indicates the following according to the event
type.
Terminal input: Terminal used for the terminal alarm
recording.
VMD: Camera channel
Command alarm reception: Camera channel
Note:
The camera selection buttons (1 - 10/0) are available for
the camera channel selection.
I Rec. Quality
I Rec. Frame Rate
These settings can be configured in the same manner as
for "Manual Rec. Setup". Refer to page 57 for further infor-
mation.
I Term (Alarm Duration)
Determine the alarm action to be taken and the time range
when the alarm action is to be taken upon a terminal input
or a command alarm reception. The alarm action to be
taken can be determined from the following.
AL-M: All the set alarm actions will be taken upon a termi-
nal input.
AD-M: Some of the alarm action will be taken upon a termi-
nal input.
(Refer to the "Action at an event occurrence (alarm
action)" section on page 27.)
Off: No alarm action will be taken.
Default: Alarm Duration 1: 00:00 - 24:00, Off
Alarm Duration 2: 00:00 - 24:00, AL-M
Note:
When "AL-M" and "AD-M" of 2 different alarm durations
are set in the same time range, the alarm action will be
taken according to the setting for the alarm duration
with "AL-M".
01 SP Fine Full
Off 00:00 24:00 AL-M
01
Off 00:00 24:00 Off
01
10
Set
Set→
OK Cancel
I Term (Rec. Channel)
Set the camera channel to be used for the alarm recording
upon a terminal input or a command alarm reception.
00 - 16
When "00" is selected, images from all of the camera
channel will be recorded.
Default: (Same value set for "Alarm No.")
I VMD (Alarm Duration)
Determine the alarm action to be taken and the time range
when the alarm action is to be taken upon a VMD alarm.
The alarm action to be taken can be determined from the
following.
AL-M, AD-M, Off
Default: 00:00 - 24:00, Off (for both Alarm Duration 1 and
2)
I VMD (Rec. Channel)
The camera channel used for the alarm recording upon a
VMD alarm will be displayed.
The displayed camera channel is the same camera channel
number as "Alarm No." (camera channel number from
which the VMD alarm is detected). Editing is unavailable.
I VMD (Sensitivity)
Set the sensitivity level of the VMD function.
01 (high) - 99 (low)
Default: 10
59