Panasonic WJ-RT416 Installation Manual page 64

I Advanced Setup
The following window will be displayed when the [SET] but-
ton is pressed after moving the cursor onto "Set→".
Network Setup (Advanced)
DNS
IP Address (Primary)
IP Address (Secondary)
Server Port
OK
w Configure the RS485 settings [RS485 Setup]
Configure the RS485 settings.
RS485 Setup
Baud Rate
Data Bit
Parity
Stop Bit
OK
I Baud Rate
Select a line speed for data communication with the con-
nected device from the following.
2 400/4 800/9 600/19 200/38 400 (bps)
Default: 19 200 (bps)
I Data Bit
The data bit will be displayed. It is impossible to change
the value.
I Parity
A method of checking for errors in communication function-
ing will be displayed. It is impossible to change the value.
I Stop Bit
The stop bit type will be displayed. It is impossible to
change the value.
64
Off
---.---.---.---
---.---.---.---
02000
Cancel
19200
8
None
1
Cancel
I DNS
Select "Manual" or "Auto" to enable IP address searching by
the host name using the DNS.
Select "Off" when not using the DNS.
Selecting "Auto" is available only when "On" is selected for
"DHCP" (using the DHCP server).
When "Manual" is selected for the DNS, enter the DNS serv-
er addresses in "IP Address (Primary)" and "IP Address
(Secondary)".
Enter 4 units from the decimal numbers (0-255) according
to the network configuration.
Default: Off
Server Port
Set the server port number of the recorder (required to use
the monitoring software).
1 - 65535
Default: 2000
e Configure the PS·Data settings [PS.Data
Setup]
Configure the PS·Data settings.
PS.Data Setup
Unit Address(System)
Unit Address(Controller)
Baud Rate
Data Bit
Parity
Stop Bit
Retry Timing
Alarm Data
Camera Number Setup
OK Cancel
I Unit Address (System)
A unit address (Sys) is a unique number assigning to
PS·Data devices. The addresses must be unique to
identify system devices when connecting multiple
devices compatible with PS·Data.
Numbers, "001"-"099", are to be assigned as the unit
addresses to the system devices.
Default: 001
I Unit Address (Controller)
A unit address (Ctrl) is a unit address assigning to con-
trol PS·Data devices. Numbers, "002"-"099", are to be
assigned as the unit addresses to the system controller.
Default: 002
001
002
9600
8
None
1
Off
1s
Set