Panasonic WJ-RT416 Installation Manual page 36

Stop power supply to the HDD
When replacing the HDD, it is necessary to stop power supply to the HDD in advance.
Contact your dealer when it is necessary to replace the HDD.
Screenshot 1
Display the "Disk Management" window ( page 33).
Disk Management
No. Capacity
1 232.884GB
2 232.884GB
3 Disk Access Error
4 232.884GB
5 No Disk Detected
6 No Disk Detected
[REC]:Start Format
All Format
Screenshot 2
The following message window will be displayed after
around 30 seconds.
The power supply of the HDD have been
turned off. Replace the HDD and
press [SET] button to turn on again.
Screenshot 3
The "Disk Management" window will be displayed again.
Disk Management
No. Capacity
1 232.884GB
2 232.884GB
3 Disk Unformatted
4 232.884GB
5 No Disk Detected
6 No Disk Detected
[REC]:Start Format
All Format
36
Used Hour Meter
232.250GB 400h
232.250GB 389h
000.008GB 400h
[STOP]:Change HDD
Information Return
Replace HDD
HDD1 HDD3 HDD5
HDD2 HDD4 HDD6
OK
Used Hour Meter
232.250GB 400h
232.250GB 389h
000.008GB 400h
[STOP]:Change HDD
Information Return
Step 1
Move the cursor onto any of No.1 - 6, and then press the
[STOP] button.
→ The confirmation window will be displayed. Move the
cursor onto "OK", and then press the [SET] button.
Power supply to the HDD corresponding to the indica-
tion "Disk Access Error", "Data Error", "Disk Type
Unfitting" or "Disk Unacknowledged" will be cut.
Step 2
Replace the HDD. Contact your dealer when it is necessary
to replace the HDD.
Step 3
When completing the HDD replacement, press the [SET]
button.
Step 4
Since the replace HDD is unformatted yet, format the HDD
( page 35).