Panasonic WJ-RT416 Installation Manual page 57

w Configure the manual recording settings [Manual Rec. Setup]
Configure the settings for manual recording that starts recording when the [REC] button is pressed.
Manual Rec. Setup
Camera No.
Rec. Quality
Rec. Frame Rate
All
I Camera No.
Select a camera channel to be used for manual recording.
Note:
The camera selection buttons (1 - 10/0) are available for
the camera channel selection.
I Rec. Quality
Select an image quality for recorded images from the fol-
lowing.
SP Fine: Highest quality
Fine: High quality
Normal: Standard quality
Extended: Low quality
Default: SP Fine
e Configure the timer recording settings [Timer Rec. Setup]
Designate a day of the week and time when the timer recording is to be started (timer recording schedule).
Timer Rec. Setup
Camera No.
SUN 00: 00 24: 00 Off
MON 00: 00 24: 00 Off
TUE 00: 00 24: 00 Off
WED 00: 00 24: 00 Off
THU 00: 00 24: 00 Off
FRI 00: 00 24: 00 Off
SAT 00: 00 24: 00 Off
DAILY 00: 00 24: 00 Off
All
I Camera No., Rec. Quality, Rec. Frame Rate
These settings can be configured in the same manner as
for "Manual Rec. Setup". Refer to the "Manual Rec. Setup"
section.
I Recording time range
Set the start time and end time for the desired day of the
week, and then select "On".
Up to 2 time ranges can be set as the timer recording
schedule.
01L
SP Fine
Full
OK Cancel
01 SP Fine Full
00: 00 24: 00 Off
00: 00 24: 00 Off
00: 00 24: 00 Off
00: 00 24: 00 Off
00: 00 24: 00 Off
00: 00 24: 00 Off
00: 00 24: 00 Off
00: 00 24: 00 Off
OK Cancel
I Rec. Frame Rate
Select a recording frame rate from the following.
Full, 1/2F, 1/4F, 1/8F, 1/16F
(When "Full" is selected, recording frame rate will be 30
frames/sec for NTSC model and 25 frames/sec for PAL
model.)
Default: Full
Note:
When the [SET] button is pressed after moving the cur-
sor onto "All", the same settings for "Rec. Quality" and
"Rec. Frame Rate" will be applied to all of the camera
channels.
To set the same time range for every day of the week, enter
the start and end time for "DAILY".
When "On" and "Off" of 2 different schedules are set in the
same time range, the timer recording will be carried out
according to the schedule for which "On" is selected.
Note:
When the [SET] button is pressed after moving the cur-
sor onto "All", the same settings for "Rec. Quality", "Rec.
Frame Rate" and "Recording time range" will be applied
to all of the camera channels.
57