Electrical Installation (For Hazardous Area Oxymitter 4000 With Integral Electronics); Figure 2-7. Installation With Drip Loop And Insulation Removal; Figure 2-8. Remote Electronics Mounting - Emerson Rosemount Analytical Oxymitter 4000 Instruction Manual

Instruction Manual
IB-106-340C Rev. 4.1
July 2004
REPLACE INSULATION
AFTER INSTALLING
HAZARDOUS AREA
OXYMITTER 4000
INSULATION

Figure 2-7. Installation with Drip Loop and Insulation Removal

c. Remote Electronics Installation
For a Hazardous Area Oxymitter 4000 with
the remote electronics option, install the
probe according to the instructions in para-
graph 2-1.b. Install the remote electronics
unit on a wall, stand pipe, or similar struc-
ture (Figure 2-2 and Figure 2-8).

Figure 2-8. Remote Electronics Mounting

2-8 Installation
MOUNTING
PLATE
37260016
Hazardous Area Oxymitter 4000
LINE
VOLTAGE
STACK OR DUCT
METAL WALL
2-2 ELECTRICAL INSTALLATION (FOR
HAZARDOUS AREA OXYMITTER 4000
WITH INTEGRAL ELECTRONICS)
All wiring must conform to local and national
codes.
Disconnect and lock out power before
connecting the unit to the power
supply.
Install all protective equipment covers
and safety ground leads after installa-
tion. Failure to install covers and
ground leads could result in serious
injury or death.
Rosemount Analytical Inc. A Division of Emerson Process Management
LOGIC I/O,
4-20 mA SIGNAL
DRIP
LOOP
26310010