Table of Contents
Advertisement
Instruction Manual
IB-106-340C Rev. 4.1
July 2004
GENERAL PRECAUTIONS FOR HANDLING AND
STORING HIGH PRESSURE GAS CYLINDERS
Edited from selected paragraphs of the Compressed
Gas Association's "Handbook of Compressed Gases"
published in 1981
Compressed Gas Association
1235 Jefferson Davis Highway
Arlington, Virginia 22202
Used by Permission
1.
Never drop cylinders or permit them to strike each other violently.
2.
Cylinders may be stored in the open, but in such cases, should be protected against extremes of weather and, to prevent
rusting, from the dampness of the ground. Cylinders should be stored in the shade when located in areas where extreme
temperatures are prevalent.
3.
The valve protection cap should be left on each cylinder until it has been secured against a wall or bench, or placed in a
cylinder stand, and is ready to be used.
4.
Avoid dragging, rolling, or sliding cylinders, even for short distance; they should be moved by using a suitable hand-
truck.
5.
Never tamper with safety devices in valves or cylinders.
6.
Do not store full and empty cylinders together. Serious suckback can occur when an empty cylinder is attached to a pres-
surized system.
7.
No part of cylinder should be subjected to a temperature higher than 52°C (125°F). A flame should never be permitted to
come in contact with any part of a compressed gas cylinder.
8.
Do not place cylinders where they may become part of an electric circuit. When electric arc welding, precautions must
be taken to prevent striking an arc against the cylinder.
P-22
Hazardous Area Oxymitter 4000
Rosemount Analytical Inc. A Division of Emerson Process Management
Advertisement
Table of Contents
