Assembling The Speakers As Stand Types - Panasonic SC-ELS10 Operating Instructions Manual

• Do not apply an unreasonable force to the net at the front of the speaker unit. You cannot remove the front net.
• You can carry out assembly work stably by placing the cushions in the packing case beneath the speaker.
Place the speaker unit with the net side facing downward.
• Be sure to spread a cloth, for example, on the floor to protect it from damage.
• After each task, tighten the screws securely.
n Cushions used
 Speaker units.
 Use the four cushions at the very top of the SB-FS1010.
n Method of setting cushions
 Place these surfaces face up.

Assembling the speakers as stand types

1
Fit the stand bases onto the front
speaker R and surround speaker L
stands.
Align the two projections in the front speaker R

and surround speaker L stands  (included)
with the two holes in the front R (or surround
speaker L) stand base  (included), and fit
together.
• The packing bags for the stand bases and the
packing bags for the speakers are held in place by
tape of the same color. Assemble the bases and
speakers with the same color tape.
• The sticker "Attach the stand base on this side." is put
on the inner side of the stand base attaching side.
 Attach the stand base using the two stand base
mounting screws (included).
Use the two screw holes marked "Front-R/Sur.-L" to
attach the base. 
• Align the positions of the holes marked "Front-R/
Sur.-L" with the positions of the screw holes in the
stand.
• When assembling the front speaker L and
surround speaker Ｒ , use the screw holes marked
"Front-L/Sur.-R" and fit.
• Tighten the screws alternately, and finally tighten
them hard.
Reverse side of stand base
sticker (inside)
Front-R/Sur.-L
Front-R/Sur.-L Front-L/Sur.-R
Front-L/Sur.-R Front-R/Sur.-L
Front-R/Sur.-L Front-L/Sur.-R
Front-R/Sur.-L
Continued on the next page
9
RQT8979