Table of Contents
Advertisement
Testing the System
Pager Communication
Use the following table to determine what the numeric mes-
sage is reporting.
Pager Reporting Message
Reports
Phone Test
AC Power Restoral
AC Power Failure
Latchkey
No Activity
Panic Code
Emergency
Intrusion
Fire
Openings
Closings
Fail to Open
Fail to Close
Testing 2-Way Voice Operation
To initiate an audio session, the central station operator must
perform the following steps:
1.
After the panel has completed reporting the alarm, pick
up the CS phone and press the ‚ button to start the
audio session.
2.
Press 1 or 0 to speak, 2 for VOX operation, and 3 or 6
to listen.
3.
Press 99 to terminate the session.
Note
Panel voice announcements are silenced during AVM
sessions. If the operator does not terminate the session
correctly, panel announcements may not occur for up to
90 seconds after the operator hangs up.
Note
To conduct an audio session using remote phone access
see the Table "Phone Commands for Remote Access" in
the "Testing" section.
30
Beta Test 8/10/01
Numeric
Message
-101 -101
-102 -102
-103 -103
-104 -104
-105 -105
-106 -106
X-10 Lamp Modules
-107 -107
Use the to determine the full extent of module testing to be
-108 -108
accomplished.
-109 -109
To test the system controlled lamp modules:
-110 -110
1.
-111 -111
-112 -112
2.
-113 -113
Siren and X-10 Lamp Module Functions
All sirens will time out in the programmed siren time-out
(Option 39, 1-254 minutes). Siren priority is as follows:
1.
2.
3.
If an alarm of greater priority occurs during an alarm of lower
priority, the greater priority alarm sirens sound. Fire alarms
will sound a temporal 3 pattern. Temporal 3 is 0.5 seconds on,
0.5 seconds off for 3 beeps then 1.5 seconds off.
Audio Verification Set
Phone
Button(s)
0-1
Speak
2
VOX operation
3 or 6
Listen
7
Extend session for 90 more seconds
88
Terminates session with call back (the panel
answers on the first ring if called within 5
minutes)
99
Terminates session with no call back
Press the LIGHT button on the Key Chain Touchpad
repeatedly to turn all lights on and off. The panel
responds with Lights on/off.
Press the Lights On button and the unit # of the lamp
module using the numeric buttons on the Remote
Handheld Touchpad to test individual lamp modules,
the panel will respond with Lights # on/off.
Fire (highest priority)
Intrusion
Emergency
Note
The X-10 must be set to unit #9 to "hear" emergency
alarm beeps.
Function
Advertisement
Table of Contents
