Table of Contents
Advertisement
Invacare® LiNX
or left by a four–quadrant (4Q) operation without additional
switches. This is different to an operation based on three
quadrants (3Q), such as a Head Array or a Four Switch
Proximity Array. There you have the possibility to move
forward, right or left with the aid of proximity sensors. In
order to allow the wheelchair to be driven in reverse or
changing function cards, an additional switch or sensor is
required.
The Head Array and the Four Switch Proximity Array are
provided with an Atom Box, so your provider can fit the
arrays to your individual needs by using the dip switches.
Default dip switch setup:
1 Reset/Reverse switch turned off.
2 Not used at the moment.
3 Turned on, to power up with wheelchair.
4 Not used at the moment.
5 Not used at the moment.
6 Audible input indicator turned off.
96
Fig. 5-154
All components mentioned below describe the usage
of the default set-up. For individual set-up, contact
your provider.
5.21.1 Using Manual Swing-Away Chin Control
WARNING!
Risk of Injury or Death
Small parts can lead to choking hazard that may
result in injury or death.
– Do not remove any small parts.
– Closely supervise children, pets or people with
physical/mental disabilities.
CAUTION!
Risk of Injury and Damage
Remaining burrs and missing end caps after
modifications on rods, such as shortened rod, can
lead to injury or damage.
– Deburr cut after cutting excessive length.
– Re-install end cap after deburring.
– Check end cap for tight fitting.
CAUTION!
Risk of Injury or Damage
Clothes or personal accessories can restrict or
prohibit correct function of Chin Control.
– Check correct wiring of cables before first use.
– Ensure that no clothes or accessories are in
range of use at any time.
1637425-I
Advertisement
Table of Contents
